Call Us
(813) 440-8108
Showing guides tagged contractors. Show all
-
Furnace Blower Runs Constantly but No Heat: Thermostat, Board or Motor?
When the furnace blower keeps running and the burners stay off, the blower is usually following orders. How to read the board, find the cause and leave the motor for...
Read now -
The System Runs but the Blower Doesn't: Working the Split
When the condenser runs and the indoor blower stays dead, the symptom itself narrows the fault. How to split the circuit and land on the cause before ordering a motor.
Read now -
Wiring an X13 Blower Motor: Power, Taps and the Retrofit Traps
The X13 wires differently than the variable-speed motor it often replaces. What goes to the power connector, what the control pins expect, and where retrofits go wrong.
Read now -
Getting a Seized Blower Wheel Off the Shaft
On most motor swaps the wheel is the hard part, not the motor. How to get a seized wheel off without ruining it, and how to set it back on...
Read now -
Blower Motor Rotation: How to Tell CW from CCW Before You Order
Rotation is the one spec no cross-reference chart can work out for you. How to read it, how to confirm it off the old motor, and what happens if you...
Read now -
How to Read an HVAC Blower Motor Nameplate
Every field on a blower motor nameplate, what it actually tells you, and which four decide whether the replacement bolts in and runs.
Read now -
Alternative to The Dealer Toolbox for Genteq ECM Motors (2026)
The Dealer Toolbox identifies the part and sends you to a distributor. Here is the ungated alternative: cross reference the Genteq or OEM number, see the price and buy the...
Read now
